Scooba cleaning system

Scooba uses for each passage, four cleaning methods.
Pick one - Scooba gets dirt and broken glass (remove) located on your floor. You do not need to sweep the floor before using Scooba unless impurities have more important.
2 Washing - Scooba continuously pours a small amount of cleanser clean and new.
3 polishes - Scooba gently polishes to remove dust and waste.
4 Hair - The Scooba vacuum wand recovers the dirty water and debris to leave your floor clean and dry.
Scooba cleaning will continue as long as there's cleaner in the tank clean, or for nearly 45 minutes. Once the cleaning cycle is finished, Scooba start a drying cycle.
Drying mode internal
U
When does the cleaning cycle is finished, Scooba will enter a drying mode internal short enough to remove all liquids would have stayed on his brushes and his cleaning mechanisms. During this stage, the LED flashes indicating cleaning.
TIP: If you want to stop the cleaning cycle to its end, iRobot
recommends that you first activate the internal drying mode:
• To activate the drying mode while the robot cleans
simply press Clean (Clean).
• To start drying mode while Scooba is off, press the Power (On), then twice Clean (Clean).